Trypophobia Tinsley 3D FX Transfer

Trypophobia is real… we can hardly stand writing this! Make it look like you’ve got a serious maggot infestation this Halloween when you apply this maggot wound 3D transfer! Made by Tinsley Transfers, this easy to apply maggot wound is latex free and applies just with water just like a temporary tattoo (how simple!). With it’s realistic finish, there’s no wonder this range of prosthetics are used in Hollywood productions!

Description:

• Trypophobia is a film quality, latex free special FX transfer.
• Includes one trypophobia wound with maggots.
• Wound applies simply with water like a temporary tattoo and blend into your skin.
• Full application instructions on the back of the packaging.
• Prosthetic is made in the USA.

How To Apply:

• Carefully cut the top off the packaging
• Remove the wound from the packaging – it should be on a white backed card
• Peel the plastic sheet away from the white card – the wound should be stuck to the plastic sheet leaving the white card blank
• Place the appliance face down (sticky side down) onto the white blank card
• Push out any trapped air and firmly press the appliance down onto the white card
• Cut out around the appliance – this can be done all in one or in sections if you wish to apply sections seperately
• Prior to applying to the skin, thoroughly clean the area and remove any dirt, oils, makeup or excessive body hair
• Once the appliance is firmly pressed on the white card, you can peel the plastic layer off
• Place the appliance sticky side down onto the skin and press firmly
• Once appliance is pressed onto the skin, wet the paper with a damp cloth or sponge
• Once the paper is thoroughly damp, slowly peel the paper off and the wound should now be stuck to the skin
• Press any loose edges down with a wet finger
• Add blood and makeup to complete your look